- How do you update a 200 sprocket?
- How do you reset a sprocket printer?
- How long does a sprocket take to charge?
- Why won’t my sprocket 200 turn on?
- Why is my sprocket not connecting?
- Why is my sprocket light red?
- How do you reset a sprocket plus?
- Can sprocket print while charging?
- Can you use Sprocket paper in sprocket plus?
How do you update a 200 sprocket?
Make sure your mobile device is connected to the Internet and then open the HP Sprocket app.
If there is a firmware update available, a firmware update screen displays.
Follow the on-screen prompts to complete the update.
Your printer must be charged to 25% or higher before a firmware update..
How do you reset a sprocket printer?
How do I reset my printer?Turn on the printer.Locate the Reset button near the charging port.Gently insert the straight pin into the reset button access point, and then press the Reset button for 3 seconds. The printer resets and turns off.Turn on the printer.
How long does a sprocket take to charge?
90 minutesHP recommends you charge the printer up to 90 minutes or until the power light turns green. However, you can charge the printer for longer than 90 minutes, which might increase battery life.
Why won’t my sprocket 200 turn on?
If the printer does not turn on when you press the Power button, reset the printer to clear any errors. Remove the paper cover. Locate the Reset button. With a paperclip or pin, press and hold the Reset button for 3 seconds.
Why is my sprocket not connecting?
Make sure your mobile device settings allow a connection with your Sprocket. Turn on the Sprocket. On your mobile device, open the Bluetooth settings menu, and then make sure Bluetooth is enabled. Check the settings on your Android or iOS device.
Why is my sprocket light red?
If the Status Indicator light is blinking red, the printer is in an error state, and an error message displays on the HP sprocket app. For more information, go to Blinking Red Status Indicator Light. If the Charging Indicator light is blinking red, the battery has a very low charge, or is unable to charge.
How do you reset a sprocket plus?
Slide the paper cover Locate the Reset button. Gently insert a straight pin into the reset button access point, and then press and hold the Reset button for 3 seconds. The printer resets and turns off.
Can sprocket print while charging?
Printer can be used while charging. Fully charged Device is fully charged. Powering on/Receiving print job LED flashes white when powering on and when receiving a print job. Printer error When a print error occurs, the LED will flash red.
Can you use Sprocket paper in sprocket plus?
No, the 2×3-inch size paper will not work with the HP Sprocket Plus printer. The only paper that works with the new Sprocket Plus Printer is HP Sprocket Plus Photo Paper, 2.3×3. 4-inch. … Make sure you buy the right size paper!